1
2
2
1
Adjusng the Viewing Angle of the Phone
(Oponal)
The ShoreTel IP Phone stand supports two lt angles for the phone on desk.
The stand is shipped in the low posion. Use these instrucons to change the lt angle.
Remove the Stand:
1. Grasp the phone base in one hand and the stand in the other.
2. Pull the stand o the base unl it unsnaps.
Replace the Stand:
1. Rotate the stand 180 degrees. Seat the stand rmly in the hooks.
2. Push the stand into the base unl it snaps into place.
Connecng to Power over Ethernet
Required Items:
l Ethernet cable for ShoreTel IP Phone (included)
l Network wall port that supports power or Power over Ethernet (PoE)
Note: This conguraon describes a Power over Ethernet connecon. Refer to Connecng to Power
and the Network on page 2 if your network wall port or data switch does not support Power over
Ethernet.
IP Phone 480/480g/485g
Quick Install Guide
Connecng a Headset (Oponal)
The ShoreTel IP Phone supports use of an oponal Headset, as shown. Aer connecng the
headset, select the Headset buon on the front panel of the ShoreTel IP Phone.
Remove
Replace
ShoreTel, Inc. l www.shoretel.com
Refer to http://www.shoretel.com/products/ip_phones for more information
Part Number: 800-1540-01
4
1
Connect Power over Ethernet:
1. Connect one end of the Ethernet cable to the Ethernet port on the ShoreTel IP Phone.
2. Connect the other end of the Ethernet cable to a network wall port that
supports Power over Ethernet. Aer a few seconds, the ShoreTel IP Phone
powers on and runs through a series of system tests.
Note: IP Phone 480 supports 10/100 Ethernet network speed. IP Phones 480g/485g support 10/100/1000 network speed.
Low angle
High angle
1
2
Comments to this Manuals